HiTEX Gear Bi-Metal Delta Chip - Blue Titanium with Copper Slug, Laser Engraved Delta (HITEX-CHIP-DELTA-BIMETAL-BLUE)

Blue titanium chip with a copper slug hydraulically pressed into the center, Delta engraved on both sides.

HiTEX brought the Bi-Metal Delta back from the early days of the brand. The body is titanium in blue with a milled edge, and a copper slug is pressed into the middle of each side with the classic Delta laser engraved into it.

Specifications

• Brand: HiTEX Gear
• Model: Bi-Metal Delta Chip, standard size
• Body Material: Titanium
• Body Finish: Blue
• Center: Copper slug, hydraulically pressed
• Engraving: Delta, laser engraved both sides
• Edge: Milled
• Stackable: Yes

Blue Against Copper

Blue and copper is the pairing people reach for first, and it works because the two are as far apart in temperature as metal finishes get. Cool body, warm center, no ambiguity about where your eye lands.

It also deepens over time. The copper darkens with handling while the blue body stays put, so the gap between the two widens the more you carry it.

What a Chip Actually Is

A casino style chip machined out of metal, meant to live in a pocket and get handled. Flipped, spun, rolled across knuckles, set on a desk and picked up again. There is no function to it beyond that and nobody who owns one is confused about that.

What makes a good one is weight, edge geometry, and how the surfaces feel after a few thousand handlings. A chip with the wrong mass or a sharp edge gets put in a drawer. This is a category where the machining is the entire product.

They Stack

HiTEX builds these to stack the way casino chips do, so a collection sits in a column on a desk rather than scattered in a tray. Most people who buy one end up buying more, and the stacking is a large part of why.

Bi-Metal Means Two Metals

Titanium body, copper center. They are not plated or coated. The copper slug is hydraulically pressed into the titanium, so it is held by the fit rather than by adhesive.

The Delta

The Delta is one of HiTEX's original designs and this run brings it back. Nested triangles laser engraved into the copper on both sides, so the chip reads the same whichever way it lands.

Milled Edge

The perimeter is cut into segments rather than left round. That is what gives your fingers something to index against when you are spinning or flipping it, and it is the difference between a chip that stays in a pocket and one that does not.

About HiTEX Gear

HiTEX Gear is Mike Bond, who also runs Ti2 Design and Bond Knives out of Hawaii. We met him at the California Custom Knife Show in the fall of 2026 and picked these up directly.